Step 3: Insert the dowel rods into each slit.

Step 4: Cut another piece of cardboard in a circular shape with a diameter of around 10cm.

Step 5: Cut out four evenly spaced slits around the circular piece.

Step 6: Glue both the rectangular and circular cardboard pieces together with the dowel rods at the bottom of the rectangular piece and the circular piece at the top.

Step 7: Tie the rubber bands around the dowel rods and attach them to the slits on the circular piece.

Controls

The controls of DIY Joystick are simple but require some practice to master. Here's how the controls work.

To move the joystick forward:
The player must stretch the rubber bands of the joystick in a forward motion and release them, allowing the rubber bands to snap back.

To move it backward:
The player must stretch the rubber bands of the joystick in a backward motion and then release them, allowing the rubber bands to snap back.

To stop the joystick:
The player must hold the joystick in a neutral position, with the rubber bands loose.

Tips and Tricks

1. Keep it clean:

Make sure to keep the joystick clean and free from any dirt or debris. Any debris can get caught in the rubber bands, causing the joystick to stick or slower in motion, making it difficult to play.

2. Tension matters:

Adjust the tension of the rubber bands according to your preference. You can add or remove rubber bands to adjust the tension, making it easier or more challenging to move the joystick.

3. Patience is key:

Be patient when playing DIY Joystick, especially when trying to move the joystick. It requires a lot of practice to master moving it quickly and accurately.

4. Start slow and steady:

Start with slow, gentle motions and gradually increase the speed. Start with small movements to get comfortable with the joystick's motion to avoid making a mistake or losing control of the game.

5. Use both hands:

When playing DIY Joystick use both hands. One hand should be used to control the joystick while the other hand should be used to steady the base.

6. Master the neutral position:

Mastering the neutral position is critical when playing DIY Joystick. Holding the joystick in a neutral position takes practice because it requires keeping the joystick steady and keeping the rubber bands loose.

7. Be mindful of the rubber bands:

The rubber bands tend to wear out over time, and it’s essential to replace them after a while. Make sure to monitor the tension of the rubber bands to keep them from being overstretched, which can cause them to snap.

8. Keep your distance:

It's important to maintain a safe distance from other players when playing DIY Joystick. Players should be far enough apart to avoid collisions and ensure that their joystick's movement does not interfere with the other player's joystick movement.

9. Practicing makes perfect:

The key to mastering DIY Joystick is to practice as much as possible. The game requires a lot of hand-eye coordination and timing, both of which need practice to perfect.

Conclusion

DIY Joystick is a fun and unique game that requires some creativity and skill to master. Building the joystick is easy, but mastering the controls takes patience, practice, and skill. Keeping the joystick clean and adjusting the tension of the rubber bands is critical to make the game more or less challenging. With these tips and tricks, you will be able to build and play DIY Joystick like a pro!